Kramer Electronics 97-01014035 Flat Hdmi Cable 35 Ft

Product Description

The KRAMER ELECTRONICS 97-01014035 is a flat HDMI cable with a male-to-male configuration and built-in Ethernet channel. At 35 feet in length, it carries high-definition audio and video signals between source devices and displays while allowing network data to pass over the same cable when connected to compatible HDMI Ethernet Channel (HEC) enabled equipment. The flat jacket design reduces bulk and simplifies cable routing in tight installations. AV integrators and low-voltage technicians install this cable in commercial and residential signal distribution runs.

This cable is suited for permanent and semi-permanent AV installations where a clean, low-profile cable run is required. Typical applications include boardrooms, classrooms, hospitality display systems, and home theater setups where a 35-foot run from a source device to a display is needed. The flat form factor makes it easier to route under carpet, along baseboards, or through shallow raceways compared to round cables of equivalent length.

Key Features

• Flat cable jacket for low-profile routing under carpet, along walls, or through raceways
• Male-to-male HDMI connectors on both ends for direct source-to-display connections
• Built-in HDMI Ethernet Channel (HEC) support for network data over the same cable
• 35-foot length suitable for mid-range AV signal runs without an active extender
• Single-unit packaging for straightforward individual deployment

Compatibility

Designed as a standard male-to-male HDMI replacement or installation cable compatible with HDMI-equipped source devices and displays including projectors, monitors, televisions, AV receivers, and switchers that use a full-size HDMI port.

Installation Notes

Low-voltage AV technicians and installers typically handle HDMI cable runs. Power down all connected source and display equipment before connecting or disconnecting the cable. Avoid sharp bends at connectors or along the cable run to prevent signal degradation over the length of the cable. When routing under carpet or through conduit, ensure the flat jacket is not pinched or crimped, as physical damage can compromise signal integrity.