Kleenguard 41504 Disposable Coveralls Medium 25/case

Product Description

The KLEENGUARD 41504 is a disposable hooded coverall designed for liquid and particle protection in surface preparation, painting, and general industrial work. Built from microporous film laminate, the coverall provides a water-resistant barrier while remaining lightweight enough for extended wear. The zipper front closure, elastic wrists, and elastic ankles deliver a secure fit that limits particle ingress and liquid splash exposure. Each unit features serged seams for basic structural integrity. Sized for medium-build workers, this coverall is suited for use by painters, HVAC techs, contractors, and industrial service personnel who need disposable PPE that meets NFPA 99 standards.

The KLEENGUARD 41504 is intended for non-cleanroom environments where liquid splash and airborne particle exposure are the primary hazards. Typical applications include spray painting, surface prep, insulation handling, light chemical handling, and general maintenance work in residential and commercial settings. Each case contains 25 individually usable coveralls, making restocking straightforward for service fleets and job-site supply kits. The garment is rated Non-Hazardous Protection level and is not intended for use in environments requiring CBRN or classified chemical protection.

Key Features

• Microporous film laminate construction provides liquid splash resistance and particle barrier protection
• Water-resistant zipper front closure for quick donning and a secure seal
• Elastic wrists and ankles (EWA) for a fitted, protective seal at extremities
• Attached hood included for head and neck coverage during spray or particulate work
• Serged seams throughout for consistent construction on a disposable garment
• 25 garments per case for efficient inventory management on active job sites

Compatibility

Designed as a disposable single-use coverall for non-cleanroom industrial and commercial applications where liquid and particle protection are required. Meets NFPA 99 standards as noted in product specifications.

Installation Notes

Coveralls should be inspected before each use for tears, compromised seams, or zipper defects. Don the garment over work clothing in a clean area before entering the hazard zone. Remove and dispose of the coverall carefully after leaving the work area to avoid transferring contaminants. These are single-use garments and must not be laundered or reused.