Kipp K0117.3A41X25 Adjustable Clamping Handle 3/8-16

Product Description

The KIPP K0117.3A41X25 is an adjustable clamping handle with a threaded stud connection designed for securing and positioning components in industrial, machine tool, and mechanical assembly applications. The handle body is die cast zinc with a powder-coated black finish, while the stud and hardware components are stainless steel with a black oxide finish. Key dimensions include a 3.11-inch handle length, a 0.83-inch hub diameter, and a 0.98-inch stud length on a 3/8-16 thread. The 20-degree arm angle and ball-end arm style allow repositioning for ergonomic access in tight or angled mounting situations. Mechanical technicians and machine builders typically specify and install this handle type.

This handle suits residential and commercial machine tool fixtures, jigs, workholding equipment, and general industrial machinery where a hand-adjustable clamping point is needed. The 3/8-16 threaded stud mounts directly into a tapped hole in the target assembly. Its compact base diameter of 0.63 inches and base height of 0.39 inches keep the installed footprint small. The zinc die cast body keeps weight low at 0.3 pounds while providing adequate rigidity for clamping loads typical of manual hand-tightened fastening.

Key Features

• 3/8-16 threaded stud for direct installation into standard tapped holes
• Adjustable arm with 20-degree angle and ball-end style for ergonomic repositioning
• Die cast zinc body with powder-coated black finish for corrosion resistance in light industrial environments
• Stainless steel stud and components with black oxide finish for added durability
• Compact hub diameter of 0.83 inches suits space-constrained mounting locations
• Meets material specification DIN EN 12844 for zinc die castings

Compatibility

Designed as an OEM-style or direct-replacement adjustable clamping handle for machinery, fixtures, and mechanical assemblies requiring a 3/8-16 threaded stud mount point.

Installation Notes

Installation is performed by mechanical technicians or machine builders. Thread the stud into a properly tapped 3/8-16 hole and hand-tighten to the desired clamping position. Ensure the mating tapped hole is clean and free of debris before installation. De-energize or lock out any powered equipment before servicing or replacing clamping handles on active machinery per applicable OSHA lockout/tagout procedures.