Jmf 2546032321200 Reducing Tee 2x2x3/4 in Copper

Product Description

The JMF COMPANY 2546032321200 is a copper reducing tee fitting designed for plumbing and HVAC piping systems where a branch line of a smaller diameter must be teed off a main run. All three connections are copper, with connection sizes of 2 inches on the run ends and 3/4 inch on the branch outlet. Outer dimensions measure 2-1/8 inches by 2-1/8 inches by 7/8 inches OD. The fitting is constructed entirely of copper, making it suitable for potable water, hydronic heating, and refrigeration-adjacent piping applications where corrosion resistance and reliable soldered joints are required.

This reducing tee is used in residential and light commercial plumbing and mechanical systems where a 2-inch copper main line requires a 3/4-inch branch takeoff. Typical applications include domestic hot and cold water distribution, hydronic radiant or baseboard heating loops, and general mechanical room piping. Licensed plumbers and HVAC technicians install this fitting as part of sweat-soldered copper piping assemblies.

Key Features

• All-copper construction for durability and compatibility with soldered joints
• 2-inch run connections on both ends accommodate standard 2-inch copper pipe
• 3/4-inch branch outlet allows a reduced-size takeoff from the main line
• OD dimensions of 2-1/8 inches by 2-1/8 inches by 7/8 inches for accurate layout planning
• Suitable for potable water, hydronic, and mechanical piping systems

Compatibility

Designed as an OEM-style replacement and new-installation fitting compatible with standard 2-inch by 2-inch by 3/4-inch copper sweat piping systems.

Installation Notes

Installation is performed by a licensed plumber using standard copper sweat-soldering tools including a torch, solder, and flux rated for the intended service. Shut off and depressurize the water or fluid system and allow all pipes to cool completely before cutting in the fitting. Follow applicable plumbing codes including IPC and local amendments for joint preparation, flux application, and solder type, especially on potable water lines. Do not force-fit or over-heat the fitting, as copper is subject to deformation at excessive temperatures.