Jeffrey Alexander MO6373-12ABM-D Appliance Pull Handle

Product Description

The JEFFREY ALEXANDER MO6373-12ABM-D is a forged-look flat bottom appliance pull handle finished in Distressed Antique Brass. Part of the Belcastel 1 collection, this handle spans 13.25 inches overall with a 12-inch center-to-center hole spacing, making it suited for large appliance doors, cabinetry, and refrigerator or range installations. The low-profile flat bottom design seats flush against the mounting surface for a stable, rattle-free fit. Cabinet and appliance installers, kitchen remodelers, and millwork contractors will find this handle a direct fit for standard 12-inch boring patterns.

This appliance pull is intended for residential and light commercial kitchen installations. It is commonly mounted on refrigerator doors, dishwasher panels, range hoods, and large cabinet doors where a 12-inch center-to-center boring pattern is specified. The Distressed Antique Brass finish provides an aged, warm metallic appearance consistent with traditional and transitional kitchen design schemes. The Belcastel 1 collection offers coordinating hardware pieces for a consistent look throughout a kitchen or bath installation.

Key Features

• 12-inch center-to-center hole spacing for standard appliance boring patterns
• 13.25-inch overall length with forged-look flat bottom construction
• Distressed Antique Brass finish for a traditional, aged appearance
• 0.75-inch width and 2.3125-inch projection for a low-profile grip
• Part of the Belcastel 1 collection for coordinated hardware matching

Compatibility

Designed as a replacement or upgrade appliance pull for installations requiring a 12-inch center-to-center boring pattern. Verify door thickness and projection clearance before installation.

Installation Notes

Installation is typically performed by a cabinet installer, kitchen remodeler, or finish carpenter using a screwdriver or drill with the appropriate bit. Power down any appliance before mounting hardware directly to it. Confirm the existing or planned bore holes match the 12-inch center-to-center spacing before drilling. Do not overtighten mounting screws, as this can crack panel surfaces or strip threaded inserts.