Jeffrey Alexander 678-160MB Matte Black Cabinet Pull 160mm

Product Description

The JEFFREY ALEXANDER 678-160MB is a cabinet pull finished in Matte Black, part of the Wheeler Collection. It measures 7.5 inches in overall length with a 160 mm (approximately 6.3 inches) center-to-center hole spacing, making it a standard sizing for medium to large cabinet doors and drawers. The pull has a width of 0.4375 inches and a projection of 1.0625 inches from the cabinet face. It is a hardware component typically installed by cabinetmakers, finish carpenters, and general contractors during kitchen, bath, or furniture finishing work.

The 678-160MB suits residential and light commercial cabinetry applications where a clean, flat Matte Black finish is specified. The Wheeler Collection aesthetic is consistent with contemporary and transitional design schemes. It is appropriate for kitchen cabinet doors and drawers, bathroom vanity drawers, and built-in furniture pieces requiring a 160 mm hole spacing.

Key Features

• Matte Black finish for a clean, non-reflective appearance consistent across the Wheeler Collection
• 160 mm center-to-center hole spacing accommodates standard medium to large cabinet hardware boring patterns
• 7.5 inches overall length provides sufficient grip surface for drawer and door pulls
• 1.0625-inch projection keeps fingers clear of the cabinet face during operation
• Part of the Wheeler Collection for coordinated hardware specification across a project

Compatibility

Designed as a direct-fit replacement or new-installation cabinet pull for cabinetry bored to a 160 mm center-to-center spacing. Suitable for standard overlay and inset cabinet doors and drawers accepting a two-hole pull configuration.

Installation Notes

Cabinet pulls of this type are installed by cabinetmakers, carpenters, or finish tradespeople using a drill press or cabinet hardware jig to ensure accurate hole placement. Verify the cabinet face boring matches the 160 mm center-to-center dimension before installation. Mounting hardware such as machine screws is typically required and may be sold separately. Avoid overtightening fasteners to prevent surface damage or finish chipping around the mounting holes.