Jeffrey Alexander 635-128BNBDL Cabinet Bar Pull Brushed Pewter

Product Description

The JEFFREY ALEXANDER 635-128BNBDL is a square bar-style cabinet pull finished in Brushed Pewter, part of the Sutton Collection. It measures 5-7/8 inches in overall length with a 128 mm (approximately 5.04 inches) center-to-center hole spacing. The pull projects 1-1/16 inches from the cabinet face and has a width of 5/16 inches. This hardware is installed by cabinetmakers, finish carpenters, and general contractors on residential and light commercial millwork. It delivers a clean, contemporary profile suited to drawer fronts and cabinet doors across a range of interior styles.

The 635-128BNBDL is designed for standard 128 mm bore cabinets, making it a direct fit on most stock and semi-custom cabinetry using that common center-to-center spacing. The Brushed Pewter finish integrates well with transitional and modern interior environments. This pull is appropriate for kitchen cabinetry, bathroom vanities, built-ins, and furniture applications where a low-profile square bar handle is specified.

Key Features

• 128 mm center-to-center hole spacing fits standard cabinet bore layouts
• Brushed Pewter finish provides a muted, matte metallic appearance resistant to fingerprints
• Square bar profile offers a clean, architectural look
• 5-7/8 inch overall length suits typical drawer fronts and cabinet doors
• 1-1/16 inch projection keeps hand clearance minimal and consistent
• Part of the Sutton Collection for coordinated hardware across a project

Compatibility

Designed as a direct-fit replacement or new-installation pull for cabinets with 128 mm center-to-center hole spacing. Compatible with other hardware in the JEFFREY ALEXANDER Sutton Collection for consistent finish and style across a project.

Installation Notes

Cabinet pulls of this type are installed by cabinetmakers, carpenters, or experienced DIYers using a drill, appropriate bit, and a template to ensure accurate hole placement. Power down any adjacent under-cabinet electrical fixtures before drilling. Use the manufacturer-supplied or standard M4 machine screws appropriate to the cabinet door or drawer thickness to avoid over-penetration. Do not overtighten fasteners, as this can crack door faces or strip the threaded receiver.