Ives 223B10B Solid Brass Oval Flush Pull Oil Rubbed Bronze

Product Description

The IVES 223B10B is a solid brass oval flush pull finished in oil rubbed bronze. Flush pulls are recessed hardware components installed directly into a door face, cabinet panel, or sliding door edge to allow pulling without a projecting handle. This unit is machined from solid brass for corrosion resistance and long service life. At 3.55 inches long, 1.3 inches wide, and 0.45 inches deep, it fits standard routed mortise pockets. Finish is oil rubbed bronze, suited for period-style and transitional architectural applications. Installation is handled by finish carpenters, millwork contractors, or locksmiths during door and cabinet hardware trim-out.

This flush pull is appropriate for residential and light commercial applications including pocket doors, sliding barn doors, cabinet doors, passage doors, and specialty millwork panels. The low-profile oval form factor works in tight clearance situations where a projecting pull would interfere with adjacent surfaces or frames. The oil rubbed bronze finish is compatible with coordinating IVES door hardware in the same finish family.

Key Features

• Solid brass construction for corrosion resistance and structural integrity
• Oil rubbed bronze finish for period-style and transitional architectural coordination
• Low-profile oval form factor at 0.45 inches depth for tight clearance installations
• 3.55 inch length fits standard mortise pocket routing
• Sold individually, available in case quantities of 10

Compatibility

Designed as an OEM-style flush pull replacement or new installation component for pocket doors, sliding doors, and cabinet panels requiring a mortised oval pull in an oil rubbed bronze finish.

Installation Notes

Installation is performed by finish carpenters or door hardware installers. A mortise pocket must be routed to the dimensions of the pull body before seating the unit flush with the door face. Secure with appropriate fasteners through the mounting holes. Verify door panel thickness is sufficient to accept the 0.45 inch depth without breakthrough before routing.