Io Hvac Controls TD-3010-BM Rectangular Zone Damper 30x10

Product Description

The IO HVAC CONTROLS TD-3010-BM is a rectangular zone damper designed for zoned HVAC systems requiring precise airflow control in ductwork. Built to fit a 30-inch by 10-inch duct opening, this damper ships with a Belimo 3-wire actuator mounted on the bottom of the assembly. The 3-wire actuator configuration supports both open and close signal control, making it suitable for zone control boards and thermostatic zone systems. At 11 pounds, the unit is a solid, ready-to-install assembly. Licensed HVAC technicians and sheet metal contractors are the primary installers of this type of equipment.

This zone damper is intended for residential and light commercial forced-air zoning applications. It is specifically designed as a compatible replacement or new-installation damper for Trane and American Standard ducted HVAC systems. The bottom-mount actuator position suits installations where overhead or side-mount clearance is restricted. The 30-inch by 10-inch face size fits standard rectangular duct runs commonly found in multi-zone residential systems.

Key Features

• 30-inch by 10-inch rectangular duct opening for standard residential and light commercial duct sizes
• Belimo 3-wire actuator included for reliable open/close zone control signal response
• Bottom-mount actuator position for installations with limited side or top clearance
• Compatible with Trane and American Standard zoning systems
• Ready-to-install assembly with actuator pre-mounted at the factory

Compatibility

Designed for use with Trane and American Standard rectangular duct zoning systems. Intended for 30-inch by 10-inch duct openings in forced-air residential and light commercial applications.

Installation Notes

Installation should be performed by a licensed HVAC technician familiar with low-voltage control wiring and duct fabrication practices. Shut down the air handler and de-energize all control circuits before mounting the damper or connecting the actuator wiring. Secure the damper to the duct using sheet metal screws per standard industry practice, and verify actuator travel is unobstructed before restoring power. Wiring must comply with applicable local codes and the NEC for low-voltage control circuits.