Io Hvac Controls LD-2006 Rectangular Zone Damper 20x6

Product Description

The IO HVAC CONTROLS LD-2006 is a 20 x 6 inch rectangular two-position zone damper designed for duct zoning systems in forced-air HVAC installations. It includes an integrated 3-wire actuator and an LED indicator that confirms open or closed damper position at a glance. The damper controls airflow to individual zones, allowing a single air handler or furnace to serve multiple independently controlled areas. Licensed HVAC technicians install this component as part of a complete zoning system alongside a compatible zone control board and thermostats.

This damper is suited for residential and light-commercial forced-air zoning applications where rectangular ductwork is used. The 20 x 6 inch blade size fits standard rectangular duct of the same nominal dimension. The two-position actuator drives the blade fully open or fully closed based on a 24-volt signal from the zone control panel. It is typically installed in branch duct runs where individual room or zone control is required.

Key Features

• 20 x 6 inch rectangular blade fits standard nominal duct openings of the same size
• Two-position operation: fully open or fully closed for reliable zone control
• Integrated 3-wire actuator simplifies wiring to the zone control board
• LED indicator provides visual confirmation of damper position without removing access panels
• Designed for 24-volt low-voltage control signal from a zoning panel

Compatibility

Designed as an OEM-style replacement or new-installation zone damper for residential and light-commercial forced-air zoning systems using 20 x 6 inch rectangular ductwork and a 24-volt zone control panel.

Installation Notes

Installation should be performed by a licensed HVAC technician familiar with duct zoning systems. Power down the air handler and de-energize the zone control panel before making any wiring connections. The damper mounts inline in the rectangular duct branch run and connects to the zone board via the 3-wire low-voltage harness. Verify the LED indicator cycles correctly when the zone board sends an open and close command before sealing the duct connection.