Io Hvac Controls D-Z1-1006 Zone Damper Assembly 10x6

Product Description

The IO HVAC CONTROLS D-Z1-1006 is a two-position zone damper assembly designed for use in residential and light commercial HVAC zoning systems. It controls airflow through a single duct zone by opening or closing on command from a zone control board or thermostat, allowing conditioned air to be directed only where it is needed. The damper measures 10 inches wide by 6 inches in height and weighs 8 pounds. It is sized for standard rectangular ductwork and is installed by HVAC technicians during zoning system setup or as a replacement in existing zone-controlled systems.

This damper assembly is suited for forced-air zoning applications in residential and light commercial buildings. It fits into Zone One positions in a multi-zone HVAC layout. The two-position actuator moves the blade to fully open or fully closed, making it appropriate for systems that do not require modulating airflow control. HVAC technicians typically install this unit during new zoning installations or when replacing a failed zone damper in an existing ducted system.

Key Features

• Two-position operation: fully open or fully closed for straightforward zone control
• 10-inch width by 6-inch height fits standard rectangular duct openings
• Zone One designation supports organized multi-zone system wiring and labeling
• Rigid damper assembly construction at 8 pounds provides durable in-duct installation
• Compatible with standard low-voltage zone control boards and thermostats

Compatibility

Designed as an OEM-style replacement or new-installation damper for rectangular-duct residential and light commercial forced-air zoning systems requiring a two-position Zone One damper assembly.

Installation Notes

Installation should be performed by a licensed HVAC technician. Power down the air handler and zone control board before installing or replacing this damper. The damper must be mounted in a section of rectangular ductwork matching its face dimensions and secured according to sheet metal and duct installation best practices. Low-voltage control wiring to the actuator should be run and connected per the zone control manufacturer wiring diagram and applicable local codes.