Ingersoll Rand HH1-215F-12 Flat Chisel 12 Inch Oal

Product Description

The INGERSOLL RAND HH1-215F-12 is a flat replacement chisel designed for use with pneumatic chipping hammers. Machined from steel with a round shank, this chisel measures 12 inches overall length with a 1-inch head width and a 0.68-inch shank diameter. The oval collar shape ensures proper seating in the tool retainer. At 1.75 pounds, it delivers the mass needed for consistent material removal during chipping, scaling, and light demolition tasks. This is a direct replacement consumable intended to restore a chipping hammer to working condition without tool downtime.

This chisel is suited for construction, industrial maintenance, and mechanical trade applications where chipping hammers are used to remove concrete, weld slag, scale, mortar, or rust from metal and masonry surfaces. The flat tip profile makes it effective on broad flat surfaces and joints. Licensed tradespeople in ironworking, pipefitting, concrete work, and general mechanical service commonly stock replacement chisels of this type as standard consumables.

Key Features

• Flat chisel tip profile for broad surface chipping and scaling
• Steel construction for durability under repeated impact loading
• Round shank with oval collar for secure retention in compatible chipping hammers
• 12-inch overall length provides reach and leverage in confined work areas
• 1-inch head width suits general-purpose chipping and joint work
• 0.68-inch shank diameter for standard chipping hammer chuck compatibility

Compatibility

Designed as a replacement chisel for use with chipping hammers as specified by the manufacturer. Verify shank diameter and collar shape against your tool specifications before installation.

Installation Notes

Chipping hammer chisels are installed and serviced by tradespeople familiar with pneumatic tooling. Before swapping chisels, disconnect the air supply and verify the tool is fully depressurized. Insert the chisel shank fully into the retainer and confirm the collar is seated before resuming operation. Inspect the chisel for cracks or deformation before each use and replace if damage is found.