Ingersoll Cutting Tools 5101271 Replaceable Drill Tip

Product Description

The INGERSOLL CUTTING TOOLS 5101271 is a replaceable drill tip designed for indexable drilling systems used in metal cutting operations. This solid carbide insert features a 0.9055-inch (23.00 mm) cutting diameter, a 140-degree point angle, and a TiAlN/TiN PVD coating applied over a Grade IN2505 carbide substrate. The tip integrates coolant-through capability to support thermal management and chip evacuation during deep-hole and through-hole drilling. It is installed by machinists and toolroom technicians as a consumable component in compatible indexable drill bodies, extending tool life without replacing the entire assembly.

This replaceable tip is suited for drilling and spot drilling applications in steel workpieces, classified under ISO material group P (P15-P30). The helical, two-flute geometry with a regular spiral promotes efficient chip flow in ferrous materials. It fits Insert Seat Size 23, TPA Series drill bodies, and is identified by ISO number TPA2300R01 IN2505. Typical applications include production drilling in job shop and manufacturing environments where indexable tooling is preferred for cost efficiency and repeatability.

Key Features

• Solid carbide construction with Grade IN2505 substrate for wear resistance in steel cutting
• TiAlN/TiN PVD dual coating for heat resistance and extended tool life
• 140-degree standard point angle suited for steel entry without pre-spotting in many applications
• Coolant-through design channels fluid directly to the cutting zone for chip evacuation and thermal control
• Two-flute helical geometry with regular spiral for consistent chip flow in ferrous materials
• Clamp-held insert design enables fast tip replacement without removing the drill body from the spindle

Compatibility

Designed for use with TPA Series indexable drill bodies requiring Insert Seat Size 23. ISO number TPA2300R01 IN2505 identifies this tip within the TPA system. Primary workpiece material compatibility is steel (ISO P group, P15-P30).

Installation Notes

Installation should be performed by a qualified machinist or toolroom technician with the spindle powered down and locked out per applicable machine guarding procedures. Seat and clamping surfaces must be clean and free of chips or debris before seating the tip to ensure proper contact and runout. Use the manufacturer-specified clamp screw and torque procedure for the TPA series body. Do not exceed the drill body rated speed and feed parameters for the installed tip diameter.