Hubbell Wiring Device-kellems SHC1022ZP Cord Grip

Product Description

The HUBBELL WIRING DEVICE-KELLEMS SHC1022ZP is a straight strain relief cord grip designed to secure and protect electrical cables at conduit entry points. Constructed from zinc-plated steel, this fitting provides mechanical strain relief for cables ranging from 0.25 to 0.38 inches in diameter. It uses a 1/2 NPT thread connection and measures 1.27 inches in overall length. Rated IP66 for dust-tight and water-jet resistance, it suits installations where environmental protection is required. Electricians install this fitting during conduit termination work on enclosures, junction boxes, and control panels.

This cord grip is suited for general-duty electrical applications in both residential and light commercial settings. It is a straight-body design, making it appropriate for installations where the cable enters the conduit fitting in a direct, unobstructed path. Typical applications include panel enclosures, electrical boxes, and equipment knockouts requiring a 1/2 NPT threaded fitting. The zinc-plated steel construction resists corrosion in indoor and protected outdoor environments.

Key Features

• Straight body design for direct cable entry at conduit termination points
• Accommodates cable diameters from 0.25 to 0.38 inches
• 1/2 NPT thread for standard conduit knockout compatibility
• Zinc-plated steel construction for corrosion resistance
• IP66 ingress protection rating — dust-tight and protected against water jets
• Compact 1.27-inch overall length for tight enclosure installations

Compatibility

Designed as a general-duty straight strain relief cord grip for use with 1/2 NPT threaded conduit knockouts on electrical enclosures, junction boxes, and control panels.

Installation Notes

Installation is performed by a licensed electrician. De-energize and lock out the circuit before working on any enclosure or panel. Thread the fitting into a standard 1/2 NPT knockout and tighten with an appropriate wrench — do not overtighten, as this can damage the zinc plating or threads. Verify that the installed cable diameter falls within the 0.25 to 0.38-inch rated range before finalizing the connection. Installations should conform to applicable NEC requirements for cable and cord management at enclosure entries.