Hubbell Wiring Device-kellems FT4BK25 Floor Cable Cover

Product Description

The HUBBELL WIRING DEVICE-KELLEMS FT4BK25 is a single-channel floor cable cover designed to protect and conceal low-voltage cables, power cords, and data cables routed across floors in commercial and light industrial environments. Constructed from black polyvinylchloride (PVC), it spans 25 feet in length and accommodates cables up to 3/4 inch in diameter. The channel measures 1.21 inches wide and 0.75 inches tall internally, giving installers enough clearance for standard power or communication cables. Licensed electricians, low-voltage technicians, and AV integrators typically install this product when a permanent or semi-permanent cable routing solution is required at floor level.

This floor cable cover is suited for office buildings, classrooms, retail spaces, event venues, and other commercial settings where cables must cross open floor areas safely. It reduces tripping hazards and protects cables from foot traffic and rolling equipment. The 25-foot single-piece run minimizes seam points across longer cable paths. Its black finish blends with standard commercial flooring and cable management systems. Installers use it when surface conduit or under-floor routing is not practical.

Key Features

• Single-channel design accepts cables up to 3/4 inch in diameter
• 25-foot overall length covers extended floor runs with minimal splicing
• PVC construction resists everyday foot traffic and light rolling loads
• Black color suits standard commercial and office environments
• Overall width of 82.6 mm and overall height of 27.9 mm keep a low-profile footprint at floor level
• Channel width of 30.7 mm provides adequate clearance for typical power and data cable bundles

Compatibility

Designed as an OEM-style floor-level cable management solution compatible with standard single-conductor and multi-conductor cables up to 3/4 inch in overall diameter, including common power cords, extension cables, and low-voltage data cables used in commercial installations.

Installation Notes

Installation is typically performed by a licensed electrician or low-voltage technician in accordance with applicable NEC requirements for cable protection and routing. Power down or de-energize any circuits before routing cables through the cover. Secure the cover to the floor surface using appropriate adhesive tape or mechanical fasteners suited to the flooring type to prevent shifting or lifting. Do not exceed the maximum cable diameter rating or overfill the channel, as doing so can prevent the cover from seating flush and create a trip hazard.