Hillman Fasteners 41422 Toggle Bolt 1/8x3 in Mushroom Head 15 Pack

Product Description

The HILLMAN FASTENERS 41422 is a snap-in toggle bolt with a mushroom head profile, designed for fastening into hollow walls and ceilings where standard screws lack adequate holding surface. Each bolt measures 1/8 inch in diameter by 3 inches in length. The snap-in wing design allows single-handed insertion through the pilot hole, where the wings spring open behind the substrate and distribute the load. This fastener is commonly installed by electricians, plumbers, and general contractors when securing conduit hangers, pipe straps, junction box brackets, or similar hardware to drywall and hollow masonry surfaces. The pack contains 15 pieces.

Toggle bolts in this size range are suited for light-duty to medium-duty anchoring applications in hollow walls, drywall partitions, and drop ceilings encountered in both residential and light commercial construction. The 1/8 inch bolt diameter is compatible with common trade installations requiring a clean mushroom-head profile that sits flush or slightly proud of the finished surface. Typical uses include mounting electrical enclosures, securing HVAC hangers, and attaching plumbing support hardware to hollow substrates where through-bolting is not practical.

Key Features

• Snap-in wing design for single-handed insertion into hollow wall cavities
• Mushroom head profile provides a low-profile bearing surface at the face of the substrate
• 1/8 inch diameter by 3 inch length suits a wide range of hollow-wall anchoring tasks
• Pack of 15 reduces trips to the supply house on multi-anchor jobs
• Compatible with standard pilot hole sizing for 1/8 inch toggle hardware

Compatibility

Designed as a standard snap-in toggle bolt replacement or supply for hollow wall and ceiling fastening applications in residential and light commercial settings.

Installation Notes

Toggle bolts require a clean pilot hole drilled to the appropriate diameter for the folded wing assembly to pass through. Fold the wings flat against the bolt, insert through the pilot hole until wings spring open behind the substrate, then tighten the bolt until snug. Do not overtighten, as excess torque can pull the wings through drywall or damage the substrate. This fastener is not rated for structural load-bearing connections and should not be used as a substitute for rated anchor systems where code-mandated load values apply.