Hillman Fasteners 41420 Toggle Bolt 1/8x2 in Mushroom Head 15pk

Product Description

The HILLMAN FASTENERS 41420 is a snap-in toggle bolt designed for fastening loads to hollow walls and ceilings where a standard wood or machine screw lacks adequate backing. The mushroom head profile distributes load across a wider bearing surface, reducing the risk of pull-through on drywall and similar substrates. Each bolt measures 1/8 inch in diameter and 2 inches in length. The snap-in wing mechanism deploys behind the wall cavity once inserted through a pilot hole, then draws tight as the bolt is driven. This pack contains 15 individual toggle bolts. Electricians, plumbers, HVAC technicians, and general contractors reach for toggle bolts when hanging conduit straps, pipe hangers, junction boxes, or light fixtures on hollow partition walls.

Toggle bolts in this size range are suited for residential and light commercial applications involving hollow drywall, plaster, and similar thin-wall construction. The 1/8 inch bolt diameter is appropriate for moderate point loads where wall anchoring is required but a solid stud or blocking is not accessible. Typical install scenarios include hanging ductwork hangers, electrical boxes, cable management hardware, and light-duty shelving brackets on interior partition walls.

Key Features

• Snap-in wing toggle deploys automatically inside the wall cavity for secure anchoring
• Mushroom head profile provides a wider bearing surface to distribute clamping load
• 1/8 inch diameter x 2 inch length suits moderate hollow-wall fastening tasks
• 15-piece pack provides job-site quantity for multi-point installations
• Compatible with standard pilot-hole installation — no specialty tools required

Compatibility

Designed as an OEM-style replacement and general-use toggle bolt for hollow drywall, plaster, and thin-wall panel construction where a 1/8 inch toggle anchor is specified.

Installation Notes

Toggle bolts are installed by licensed tradespeople and general contractors working to applicable building and mechanical codes. Drill a pilot hole sized to allow the folded wings to pass through cleanly, insert the toggle with wings folded, and tighten until the mushroom head seats flush against the wall surface. Do not overtighten — excessive torque will crush drywall face paper and reduce holding strength. Confirm the wall substrate and point load are within the anchor rating before installation.