Hi-tech Duravent 062703500003 Stainless Steel Hose Clamp

Product Description

The HI-TECH DURAVENT 062703500003 is a stainless steel hose clamp designed to secure hose connections in plumbing, HVAC, and related mechanical systems. The band measures 5/16 inches wide and 0.02 inches thick, providing a low-profile clamping surface suited to tight installations. The clamp accommodates hose outer diameters from 1-1/4 to 2-5/8 inches, making it a practical choice when working with 2-inch nominal hose. Licensed trades and service professionals install this type of clamp as a standard fastening component wherever a reliable, corrosion-resistant connection is required.

This hose clamp is appropriate for residential and light commercial applications where metal contact with moisture, chemicals, or exhaust condensate demands a corrosion-resistant material. Typical install scenarios include vent connector fittings, drain line connections, flexible duct transitions, and hose-barb assemblies across HVAC, plumbing, and pool equipment service work. Its clamping range of 1-1/4 to 2-5/8 inches covers a broad span of 2-inch nominal hose and tubing outside diameters commonly encountered in the field.

Key Features

• Stainless steel construction resists corrosion in wet, humid, and chemically active environments
• Band width of 5/16 inches distributes clamping force evenly across the hose surface
• Clamping range of 1-1/4 to 2-5/8 inches suits 2-inch nominal hose applications
• Lightweight at 0.03 pounds, adding minimal mass to the assembly
• Single-piece packaging allows individual replacement without excess inventory

Compatibility

Designed as an OEM-style replacement or service clamp for 2-inch nominal hose and tubing connections in HVAC, plumbing, and pool equipment applications where a stainless steel band clamp with a 1-1/4 to 2-5/8 inch diameter range is specified.

Installation Notes

Installation is typically performed by licensed HVAC technicians, plumbers, or pool service professionals depending on the system involved. Shut off and depressurize the relevant line or duct section before removing the existing clamp or fitting the new one. A standard flat-blade or hex-drive screwdriver is used to tighten the clamp; tighten until snug and the hose does not rotate or pull free without over-compressing the hose material. Follow applicable codes such as the IPC or IFGC for connection requirements on gas or plumbing lines.