Hexarmor 1033-S (7) Cut Resistant Knit Gloves Small

Product Description

The HEXARMOR 1033-S (7) is a knit work glove rated for cut, puncture, and abrasion resistance, designed for trade and industrial applications where hand protection against sharp edges, rough surfaces, and puncture hazards is required. Built from a 15-gauge nylon and nylon-spandex shell, the glove is coated with polyurethane across the palm and fingertips to provide grip and durability where contact is most frequent. It meets ANSI/ISEA Cut Resistance Level A1, Puncture Resistance Level 2, and Abrasion Resistance Level 3. At 10 inches in overall length with a knit cuff, it fits securely on the wrist and allows full dexterity for detail work. Sold as a pair in size Small.

This glove is suited for general trade work environments including HVAC installation, light electrical work, plumbing rough-in, and pool equipment service where workers handle sheet metal edges, wire, tubing, and fittings. The textured polyurethane coating improves grip on smooth or slightly oily surfaces. The red shell with gray palm coating makes the gloves easy to locate on a job site. The unisex sizing in Small fits both men and women with smaller hand profiles.

Key Features

• ANSI/ISEA Cut Resistance Level A1 for protection against light sharp-edge hazards
• ANSI/ISEA Puncture Resistance Level 2 for resistance against needle and wire puncture
• ANSI/ISEA Abrasion Resistance Level 3 for durability against rough surfaces
• 15-gauge nylon and nylon-spandex knit shell for a close, flexible fit
• Polyurethane coating on palm and fingertips with textured grip surface
• 10-inch overall length with knit cuff for secure wrist fit

Compatibility

Designed as a general-purpose cut and puncture resistant work glove for trade professionals requiring ANSI/ISEA A1 cut protection in light-hazard hand applications.

Installation Notes

Inspect gloves before each use for tears, coating separation, or degradation that may reduce protection. These gloves are not rated as a blood-borne pathogen barrier and should not be used as a substitute for appropriate medical or chemical-resistant PPE. Replace gloves when coating wear or shell damage is visible. Follow applicable workplace PPE requirements and OSHA hand protection standards when selecting and using cut-resistant gloves.