


Ships same day if ordered by 12 pm
Manufacturer pricing rules prevent us from advertising our discount — no account or email required to see it.
Secure Payments
Easy Returns
Expert Advice
Fast Shipping
The HESTAN 13026 is a factory wire harness designed for the Aspire series built-in gas grill in the 30-inch configuration without the rotisserie option. It serves as the electrical interconnect that routes low-voltage control signals and power between the ignition system, burner components, and control board. This harness maintains proper circuit continuity across the grill's electrical architecture and is a direct OEM replacement part. Installation is typically performed by a qualified appliance or outdoor kitchen technician during a service call or component repair.
This wire harness applies specifically to the HESTAN Aspire built-in grill in the 30-inch non-rotisserie configuration. It is the correct replacement when the original harness shows signs of heat damage, failed connectors, broken insulation, or intermittent ignition faults traced to wiring. It is not compatible with the rotisserie-equipped variant or with other grill sizes in the Aspire line.
Designed for use with the HESTAN Aspire built-in gas grill, 30-inch configuration, without rotisserie. Not intended for rotisserie-equipped models or other grill sizes.
Disconnect the grill from its gas supply and isolate all electrical power sources before beginning harness replacement. A qualified appliance service technician or outdoor kitchen installer should perform this repair. Route the replacement harness following the same path as the original to avoid contact with high-heat surfaces. Verify all connectors are fully seated and insulation is clear of burner components before returning the unit to service.
Thanks for subscribing!
This email has been registered!
