Hellermanntyton 181-22013 Solid Wire Duct 2x2 White

Product Description

The HELLERMANNTYTON 181-22013 is a solid-wall wire duct designed for organizing and protecting electrical wiring inside control panels, enclosures, and equipment cabinets. The solid sidewall construction keeps conductors contained and shielded from debris, making it a practical choice for clean, organized wiring runs. At 2 inches wide by 2 inches tall in cross-section and finished in white, this duct integrates easily into standard panel layouts. Electricians and panel builders install this type of duct to route low-voltage control wiring, instrumentation leads, and other conductors in an orderly, code-friendly manner.

This wire duct is suited for use in residential and commercial electrical panels, industrial control cabinets, HVAC equipment enclosures, and automation panels. The solid-wall profile is chosen when wiring must be fully enclosed rather than accessible through slotted sidewalls. It is typically mounted in rows along panel back plates or DIN rail assemblies to establish defined wiring pathways between terminal blocks, contactors, relays, and other panel components.

Key Features

• Solid sidewall construction fully encloses conductors for a clean, protected wiring run
• 2-inch x 2-inch cross-section accommodates medium-density wiring bundles
• White finish suits standard panel interior color schemes and aids visual inspection
• Designed for mounting on panel back plates and inside electrical enclosures
• Sold individually as a single unit for flexible quantity ordering

Compatibility

Designed as an OEM-style fit for standard electrical panel and control cabinet wire management applications where solid-wall duct is specified.

Installation Notes

Wire duct of this type is installed by licensed electricians or qualified panel builders. De-energize the panel and follow applicable NFPA 70 (NEC) lockout/tagout procedures before beginning any wiring work inside an enclosure. Duct sections are typically cut to length with a fine-tooth saw or duct cutter and secured to the panel back plate with screws or adhesive mounting clips. Do not overtighten fasteners, as this can crack or deform the duct body.