Ham-let 3600007 Compression Tube Back Ferrule 10mm

Product Description

The HAM-LET 3600007 is a brass compression tube back ferrule designed for use in compression tube fittings with a 10mm outside diameter tube connection. The back ferrule is the rear sealing component in a two-ferrule compression fitting assembly, working in tandem with the front ferrule to create a leak-tight mechanical grip on tubing. It is installed by licensed plumbers, pipefitters, and instrumentation technicians in fluid and gas handling systems where reliable tube retention and seal integrity are required. The brass construction offers good corrosion resistance and machinability for general-purpose service applications.

This back ferrule is suited for use in instrumentation tubing, process piping, and fluid control systems across residential, commercial, and light industrial settings. It is designed to mate with two-ferrule compression fittings on 10mm OD tubing. Applications include compressed air lines, hydraulic instrumentation tubing, and general fluid distribution plumbing where a mechanically strong, leak-resistant tube connection is needed. The Swagelok cross-reference part number B-10M4-1 indicates dimensional compatibility with that fitting standard.

Key Features

• Brass construction provides corrosion resistance suitable for water, air, and general fluid service
• Designed for 10mm outside diameter tube connections in two-ferrule compression fitting assemblies
• Functions as the back ferrule component, providing tube grip and axial retention
• Cross-references Swagelok part number B-10M4-1 for dimensional compatibility
• Lightweight at 0.01 pounds, simplifying handling during installation

Compatibility

Designed for use with two-ferrule compression fittings accepting 10mm OD tubing. Cross-references Swagelok part number B-10M4-1. Verify fitting body and front ferrule compatibility before installation.

Installation Notes

Installation is typically performed by licensed plumbers, pipefitters, or instrumentation technicians. Before servicing any compression fitting assembly, depressurize and isolate the line completely. Ferrules are a single-use component in most compression fitting systems and should not be reused once the fitting has been fully torqued and put into service. Follow the fitting manufacturer's assembly instructions for proper tube insertion depth and nut torque sequence, and reference applicable codes such as the IPC or ASME B31.3 as required by the system type.