Ham-let 3001995 Compression Tube Connector 316 Ss 10000 Psi

Product Description

The HAM-LET 3001995 is a compression-to-male NPT tube connector machined from 316 stainless steel. It accepts a 1/4-inch outside diameter tube on the compression end and connects to a 1/8-inch MNPT port on the threaded end. Rated to 10000 psi maximum working pressure, this fitting is suited for high-pressure instrument tubing runs in process, analytical, and industrial applications. Material grade 316 stainless provides resistance to corrosion and oxidation in demanding service environments. The fitting meets ASTM A182, ASTM A213, ASTM A269, ASTM A276, ASTM A479, DIN EN10122-5, and DIN EN10272 material standards.

This connector is used in instrumentation and process piping systems where a compression tube must terminate at a threaded port on valves, manifolds, pressure gauges, transmitters, or panel fittings. Typical installations are found in oil and gas, petrochemical, power generation, and high-purity fluid handling environments. Licensed pipefitters and instrumentation technicians are the primary installers. The compact 1.29-inch overall length makes it practical for tight panel and rack installations.

Key Features

• 316 stainless steel construction meets ASTM A182, A213, A269, A276, A479, DIN EN10122-5, and DIN EN10272
• 10000 psi maximum working pressure rating
• 1/4-inch OD compression inlet to 1/8-inch MNPT outlet configuration
• Overall length of 1.29 inches for compact installation clearances
• Operating temperature range from -20 degrees F to 37 degrees F
• Swagelok cross-reference part number SS-400-1-2

Compatibility

Designed for use with 1/4-inch OD instrumentation tubing and 1/8-inch MNPT ported components. Cross-references to Swagelok part number SS-400-1-2 for direct replacement in existing instrumentation tubing systems.

Installation Notes

Installation should be performed by a qualified pipefitter or instrumentation technician familiar with high-pressure compression fitting procedures. Depressurize and isolate the system completely before removing or installing any fitting. Ensure tubing is cut square, deburred, and fully bottomed in the fitting body before tightening the compression nut. Verify thread sealant compatibility with the process fluid and confirm the system does not exceed the rated working pressure of 10000 psi.