Halder 3377.130 Dead Blow Hammer 20 Oz Nylon Head

Product Description

The HALDER 3377.130 is a 20 oz dead blow hammer with a nylon head and a replaceable tip designed to deliver controlled, rebound-free strikes. The hammer measures 11.42 inches overall length with a 1.19-inch face diameter, making it well-suited for applications where marring the workpiece or causing unintended movement is a concern. The dead blow design uses internal shot fill to absorb rebound energy, producing clean, single-impulse strikes. Weighing 1.25 pounds, it is a practical hand tool for service technicians, mechanics, HVAC installers, plumbers, and electricians who need a non-damaging striking tool during equipment assembly or component seating.

This dead blow hammer is used across a wide range of trade and industrial applications including driving components into place without surface damage, aligning flanged fittings, seating gaskets, adjusting ductwork, and general assembly tasks. The replaceable nylon tip extends the service life of the tool, allowing the face to be swapped out when worn rather than replacing the entire hammer. It is equally suited to residential service calls and light commercial work.

Key Features

• 20 oz head weight delivers consistent striking force with minimal rebound
• Nylon head construction protects workpiece surfaces from marring or deformation
• Replaceable tip design extends tool service life and reduces replacement cost
• 11.42-inch overall length provides comfortable reach and swing control
• 1.19-inch face diameter concentrates force for precise placement
• Dead blow internal shot fill eliminates bounce-back for single-impulse strikes

Compatibility

Designed as a general-purpose dead blow hammer suitable for hand tool use across HVAC, plumbing, electrical, and mechanical trade applications.

Installation Notes

No power source or lockout is required for hand tool use, but always ensure equipment being worked on is de-energized or depressurized before striking components. Inspect the nylon tip before each use and replace it when cracking or deformation is observed to maintain consistent strike performance. Use appropriate PPE including safety glasses when performing any striking or demolition work.