Gws 314876 Square End Mill 0.5 in 3 Flute Solid Carbide

Product Description

The GWS 314876 is a solid carbide square end mill designed for precise milling operations in metalworking and machining applications. Built from submicron carbide grade material, it delivers consistent edge retention and dimensional stability under demanding cutting conditions. The 3-flute geometry provides a balance between chip evacuation and surface finish quality. With a 0.5-inch mill diameter, a 2.25-inch length of cut, and a 37-degree helix angle, this end mill is suited for slotting, profiling, and peripheral milling on a variety of ferrous and non-ferrous materials. Licensed machinists and CNC operators are the primary installers of this tooling.

This end mill fits standard 0.5-inch tool holders used in vertical machining centers, CNC mills, and manual knee mills. It is well matched for production runs and job-shop work where a single-end, right-hand cutting tool with an uncoated bright finish is appropriate. The 6-inch overall length allows for extended reach into deeper pockets while maintaining rigidity within the limits of the 0.5-inch shank diameter. The Series 2030 designation identifies this as part of GWS's established general-purpose solid carbide end mill line.

Key Features

• Submicron solid carbide construction for superior hardness and edge retention
• 3-flute design balances chip clearance with finish quality
• 37-degree right-hand helix angle supports efficient upcut chip evacuation
• Center-cutting capable, allowing plunge entry into workpieces
• Bright/uncoated finish suitable for a wide range of base materials
• Single-end configuration with 0.5-inch shank for standard collet and end mill holder compatibility

Compatibility

Designed as a direct-fit replacement or standard tooling selection for any setup using a 0.5-inch end mill holder, ER collet, or side-lock holder in CNC machining centers and manual milling machines.

Installation Notes

Installation is performed by a machinist or CNC operator. The machine spindle must be fully stopped and the tool changer or quill locked before installing or removing tooling. Proper holder torque should follow the tool holder manufacturer's specifications. Inspect the shank and collet bore for chips or damage before seating the tool to ensure runout is within acceptable limits.