Guhring 9037410100000 Square End Mill 0.394 in 3 Flute Carbide

Product Description

The GUHRING 9037410100000 is a single-end, three-flute solid carbide square end mill designed for high-performance milling in ferrous and difficult-to-machine materials. It carries a FIREX coating and a 45-degree helix angle, both of which support efficient chip evacuation and heat resistance during aggressive cuts. The 0.394-inch (10 mm) diameter and 0.748-inch length of cut are sized for finish and semi-finish passes in tight-tolerance work. Right-hand cut and right-hand spiral flute geometry are standard. This tool is installed and operated by machinists and CNC tooling professionals in precision machining environments.

This end mill is suited for milling cast iron, stainless steel, and steel in both conventional and climb-milling applications. The centercutting design allows plunge entry without a pre-drilled pilot hole. The straight cylindrical shank at 0.3937 inches (10 mm) fits standard collet and end mill holders used in CNC machining centers and manual knee mills. The regular length type and 32 mm reach length make it appropriate for general-purpose slotting, profiling, and pocket milling where extended reach is not required.

Key Features

• FIREX coating for improved heat resistance and tool life in ferrous materials
• 45-degree helix angle promotes aggressive chip evacuation and smooth cutting action
• Centercutting geometry allows direct plunge milling without pilot entry
• Solid carbide construction for rigidity and wear resistance in hard materials
• Right-hand cut, right-hand spiral flute — compatible with standard CNC spindle rotation
• Straight cylindrical shank with h6 tolerance for precise collet runout control

Compatibility

Designed for use in standard straight-bore end mill holders and ER collet chucks accepting a 10 mm (0.3937-inch) shank diameter. Primary workpiece materials listed by the manufacturer are cast iron, stainless steel, and steel, with secondary compatibility noted for non-ferrous and superalloy materials.

Installation Notes

Installation should be performed by a qualified machinist or CNC tooling technician. Ensure the machine spindle is fully stopped and locked out before inserting or removing the tool from the holder. Verify collet bore size matches the 10 mm shank diameter and torque the collet nut per the holder manufacturer's specification. Confirm cutting direction is set to right-hand rotation before initiating any cut cycle.