Greenlee LS100X11SS Hydraulic Knockout Set 16 Piece

Product Description

The GREENLEE LS100X11SS is a 16-piece hydraulic knockout set designed for punching clean, round holes in electrical enclosures, panels, and conduit entry points. The set includes an 11-ton Intelli-Punch hydraulic tool paired with SlugSplitter punches and dies ranging from 1/2 inch to 2 inch conduit sizes, covering a punch hole diameter range of 0.88 to 2.4165 inches. It is rated for use on 10-gauge stainless steel and 10-gauge mild steel. Licensed electricians and electrical contractors are the primary users of this set for commercial and industrial rough-in and panel work.

The LS100X11SS is suited for residential service upgrades, commercial electrical panel installations, and industrial enclosure fabrication where precise, clean knockouts are required in heavier-gauge materials. The cordless 18-volt hydraulic tool eliminates the need for a separate hydraulic pump or hand pump, making it practical for in-the-field enclosure work. The set covers the most common conduit sizes encountered in EMT, rigid, and IMC installations from 1/2 inch through 2 inch.

Key Features

• 11-ton Intelli-Punch hydraulic tool included for consistent punch force on heavy-gauge material
• Covers punch hole diameter range of 0.88 to 2.4165 inches for 1/2 inch to 2 inch conduit sizes
• Rated for 10-gauge stainless steel and 10-gauge mild steel maximum capacity
• Cordless operation via two included 18-volt 3.0 Ah lithium-ion batteries with 120-volt AC charger
• SlugSplitter punch and die design splits the slug for easier removal
• Includes 3/4 inch draw stud and a hard carrying case for jobsite transport and storage

Compatibility

Includes 1/2 inch to 2 inch conduit SlugSplitter punches and dies compatible with standard EMT, rigid, and IMC conduit knockout applications in electrical enclosures and panels rated for up to 10-gauge stainless steel and 10-gauge mild steel.

Installation Notes

Installation should be performed by a licensed electrician in accordance with applicable NEC requirements. De-energize and lock out all circuits in any enclosure before beginning knockout work. Drill or use the draw stud pilot hole method to position the punch correctly before applying hydraulic force. Inspect punch and die edges before each use and do not exceed the rated gauge capacity for the material being punched.