Gibraltar LEP2142-G Straight Ejector Pin 13/32 in Steel

Product Description

The GIBRALTAR LEP2142-G is a straight ejector pin used in injection molding tooling and die applications. It is designed to push finished parts out of mold cavities at the end of each cycle. The pin measures 13/32 inches in diameter with an overall length of 14 inches and a pin length of 13.75 inches. Constructed from steel with a nitride finish, it provides surface hardness and wear resistance suited to the demands of repeated ejection cycles. The 11/16-inch head diameter and 1/4-inch head height are standard dimensions for seating in ejector plates. Toolmakers and moldmakers install and maintain these components during mold builds and repair work.

This ejector pin is used in plastic injection molds, die casting tools, and similar tooling setups where consistent, reliable part ejection is required. It is suited for both new mold builds and replacement of worn or broken ejector pins in existing tooling. The nitride finish helps reduce galling and friction along the pin bore, extending service life in high-cycle production environments.

Key Features

• Straight ejector pin design for standard mold ejection applications
• Pin diameter of 13/32 inches for precise bore fit
• Overall length of 14 inches with a usable pin length of 13.75 inches
• Steel construction with nitride finish for surface hardness and wear resistance
• Head diameter of 11/16 inches and head height of 1/4 inch for ejector plate retention

Compatibility

Designed as a standard-dimension straight ejector pin for use in injection molds and die tooling that accept a 13/32-inch pin diameter with a 14-inch overall length.

Installation Notes

Ejector pins are installed and replaced by toolmakers or moldmakers during mold maintenance or build. The mold should be fully de-energized, cooled, and removed from the press before ejector pin service begins. Pins must be seated properly in the ejector plate and retainer plate to prevent damage during press cycling. Verify pin fit and stroke clearance before returning the mold to production.