Gibraltar BE-1010 Die Mold Ejector Blade

Product Description

The GIBRALTAR BE-1010 is a die mold ejector blade used in injection mold tooling to push finished parts clear of the mold cavity at the end of each cycle. The blade profile — 0.032 inches thick and 0.234 inches wide — is suited for narrow or slot-style ejection windows where round ejector pins cannot provide adequate part contact. At 6.5 inches in length, this blade spans typical ejector plate setups found in standard mold bases. Toolmakers, moldmakers, and mold maintenance technicians select ejector blades based on precise dimensional tolerances, and the BE-1010 is stocked as a direct replacement component for those applications.

Ejector blades are used in plastic injection molding operations across both production and prototype tooling environments. They are commonly installed in molds producing thin-wall parts, ribbed components, or any geometry where a flat ejection surface is required. This blade is a single-piece replacement component appropriate for scheduled maintenance or emergency toolroom repairs. It is compatible with mold bases that accept blades sized to approximately 0.032 inches thickness and 0.234 inches width.

Key Features

• Blade thickness of 0.032 inches suits narrow ejection slot configurations
• Blade width of 0.234 inches provides a flat ejection face for part release
• 6.5 inch length accommodates standard ejector plate assemblies
• Sold individually, allowing single-blade replacement without surplus stock
• Designed as an OEM-style replacement for injection mold tooling maintenance

Compatibility

Designed as an OEM-style replacement ejector blade for injection mold tooling that requires a blade measuring 0.032 inches thick by 0.234 inches wide. Verify slot dimensions in the ejector retainer plate before installation.

Installation Notes

Ejector blade replacement is performed by qualified moldmakers or toolroom technicians. The mold must be fully de-energized and all hydraulic or pneumatic ejection circuits depressurized before disassembly. Blades should be measured against the retainer slot to confirm fit before pressing into position, as improper sizing can cause blade breakage or part damage during ejection. Follow the mold manufacturer's assembly procedures for ejector plate torque and alignment.