Gardner Spring C7C Utility Compression Spring 0.25in Od

Product Description

The GARDNER SPRING C7C is a utility compression spring designed for general-purpose mechanical and industrial applications. Built from steel with a zinc finish, this closed-end spring measures 0.25 inches in outside diameter and 1 inch in free length, with a wire diameter of 0.0287 inches. It delivers a spring rate of 9.58 pounds per inch and handles a maximum work load of 6.49 pounds. The compact solid height of 0.323 inches makes it suitable for tight-clearance assemblies. Trades and technicians working on HVAC equipment, plumbing fixtures, electrical enclosures, and general mechanical assemblies will find this spring a reliable replacement or build component.

This spring is suited for light-duty compression applications across residential and commercial mechanical systems. Its small outside diameter and short free length make it a common fit for valve assemblies, control linkages, panel latches, and equipment access doors. The closed end type provides stable seating on flat surfaces without additional hardware. Packaged in quantities of 12, it is practical for bench stock or service van inventory where multiple units may be needed across a single job.

Key Features

• Closed end type for stable, flat-surface seating
• Steel construction with zinc finish for corrosion resistance in typical indoor mechanical environments
• Spring rate of 9.58 pounds per inch for consistent, predictable load response
• Maximum work load of 6.49 pounds suitable for light-duty mechanical applications
• Compact solid height of 0.323 inches allows use in tight-clearance assemblies
• Packaged in quantities of 12 for efficient bench stock replenishment

Compatibility

Designed as a utility-grade compression spring for general mechanical and trade applications where a 0.25-inch OD, 1-inch free length closed-end spring is specified.

Installation Notes

Installation is typically performed by maintenance technicians or trade professionals during equipment repair or assembly. Before replacing or installing compression springs in pressurized or energized equipment, de-energize the system and relieve any stored mechanical pressure. Use appropriate hand tools and eye protection when compressing or releasing the spring. Verify that the spring seats fully and squarely against mating surfaces before reassembly to ensure consistent load performance.