Gardner Spring C13C Utility Compression Spring 0.25in Od

Product Description

The GARDNER SPRING C13C is a utility compression spring designed for general-purpose mechanical applications requiring consistent linear force across a defined travel range. It features a 0.25 inch outside diameter and a 2.5 inch free length, with a wire diameter of 0.0287 inches and a solid height of 0.737 inches. The spring rate is 3.73 pounds per inch, and the maximum work load is 6.58 pounds. Constructed from steel with a zinc finish, the C13C is suited for light-duty compression tasks in industrial, HVAC, plumbing, and mechanical assembly environments. Installation is typically performed by maintenance technicians or assemblers as part of component-level mechanical work.

The C13C is appropriate for residential and light commercial applications where a small-diameter, moderate-length compression spring is needed. Common use scenarios include valve assemblies, damper mechanisms, actuator components, and equipment housings where controlled return force or load-bearing compression is required. The closed end type provides stable seating on flat surfaces, making it a straightforward fit for standard spring pockets and guided assemblies.

Key Features

• 0.25 inch outside diameter fits standard small-diameter spring pockets and guides
• 2.5 inch free length with 0.737 inch solid height provides defined travel range
• 3.73 pounds per inch spring rate for predictable, linear load response
• 6.58 pound maximum work load suits light-duty compression applications
• Closed end type ensures stable seating on flat or guided mounting surfaces
• Steel construction with zinc finish for corrosion resistance in typical indoor environments

Compatibility

Designed as a utility-grade compression spring for general mechanical and trade applications requiring a 0.25 inch OD, 2.5 inch free length, closed-end spring with a 3.73 pounds per inch spring rate.

Installation Notes

Compression springs of this type are installed by maintenance technicians, HVAC service professionals, and mechanical assemblers during component replacement or new assembly work. Always de-energize or depressurize the host system before accessing spring-loaded components. Ensure the spring pocket or guide is clean and free of debris before seating the spring. Do not compress the spring beyond its solid height during installation.