G E Lighting 93095552 A19 Led Bulb 10W Soft White 10 Pack

Product Description

The G E LIGHTING 93095552 is a 10-pack of A19 general purpose LED bulbs designed as a direct replacement for standard 60-watt incandescent lamps. Each bulb draws 10 watts and delivers 760 lumens of soft white light at 2,700 Kelvin, providing a warm, familiar color tone suited to residential and light commercial settings. The frosted bulb finish diffuses the light source for a clean, even output. With a rated life of 10,000 hours (approximately 9.1 years at average daily use), these bulbs are intended for long-service installations where frequent relamping is not practical. A licensed electrician or qualified maintenance technician typically handles bulk relamping on commercial accounts.

These A19 bulbs are built for general purpose lighting in residential, hospitality, and light commercial applications. The medium base (E26) format fits the vast majority of standard lamp sockets found in table lamps, floor lamps, ceiling fixtures, and wall sconces. Non-dimmable designation means these must be installed on non-dimming circuits only. The 10-pack format is suited for property maintenance accounts, lighting contractors, and multi-unit residential service work where consistent lamp specification across a property is required.

Key Features

• 10-watt LED replaces 60-watt incandescent, reducing per-lamp energy draw by approximately 83 percent
• 760 lumens output at 2,700 Kelvin soft white color temperature
• CRI of 80 for acceptable color rendering in general living and work spaces
• Frosted A19 envelope diffuses glare and softens light distribution
• Rated 10,000 hours (approximately 9.1 years) of service life
• Non-dimmable, medium base (E26) — drop-in fit for standard residential sockets

Compatibility

Designed as a direct-fit replacement for standard medium base (E26) A19 lamp sockets. Must be installed on non-dimming circuits only. Not compatible with dimmer switches, motion-sensor dimmers, or occupancy-sensor circuits configured for dimming output.

Installation Notes

Always de-energize the fixture at the wall switch and allow the existing lamp to cool before removal. Confirm the circuit is non-dimming before installation, as use on a dimming circuit may cause flickering, reduced life, or lamp failure. Medium base lamps should be hand-tightened only — do not overtighten the base in the socket. Verify fixture maximum wattage rating is 10 watts or greater before installation.