Freud DSP2930-S9 Spade Bit Set 9 Piece Wood Drilling

Product Description

The FREUD DSP2930-S9 is a 9-piece Speed Demon spade bit set designed for fast, clean hole drilling in wood. The set includes one each of the following diameters: 1/4 inches, 3/8 inches, 1/2 inches, 9/16 inches, 5/8 inches, 11/16 inches, 3/4 inches, 7/8 inches, and 1 inch. A self-feeding speed-tip design reduces the effort required to start and drive each bit, while an optimized curved paddle design accelerates chip evacuation. The shank is impact-rated for use in both cordless and corded impact drivers and drill drivers, making this set suitable for electricians, plumbers, HVAC technicians, and general contractors who drill through wood framing and structural members.

This set is built for trade applications where throughput matters. The Speed Demon geometry is engineered to produce more holes per battery charge compared to standard spade bit designs, which is a practical advantage when running conduit, pipe, or duct penetrations through wood framing on a job site. The impact-rated shank handles the torque output of modern high-power cordless impact drivers without shank deformation or bit walk. Suitable for residential and light commercial framing, rough-in drilling, and utility penetration work.

Key Features

• 9-piece set covers 1/4 inch through 1 inch in common trade increments
• Self-feeding speed-tip design reduces operator feed pressure and speeds hole-making
• Optimized curved paddle geometry improves chip evacuation for more holes per charge
• Impact-rated shank for use in corded and cordless impact drivers and drill drivers
• Increased shank stability and durability compared to standard spade bit shanks

Compatibility

Designed for use in standard 1/4 inch hex-shank cordless and corded impact drivers and drill drivers. Suitable for drilling clean holes in wood framing, engineered lumber, and similar wood substrates.

Installation Notes

Spade bit sets of this type are typically used by electricians, plumbers, and HVAC technicians during rough-in phases. Ensure the driver is set to an appropriate clutch or impact setting for the material being drilled to avoid blowout on the exit face. Withdraw the bit periodically on deep cuts to clear chips and reduce heat buildup. Eye protection is required when operating.