Freud DSP2130-P2 Spade Bit 1 X 6 Inch 2 Pack

Product Description

The FREUD DSP2130-P2 is a 2-pack of Speed Demon spade bits sized at 1 inch diameter by 6 inches in length, designed for fast, clean wood boring in both cordless and corded drill drivers and impact drivers. The high-performance speed-tip design is self-feeding, allowing the bit to pull itself into the material without excessive downward pressure. This reduces operator fatigue and increases drilling speed compared to traditional spade bits. The impact-strong shank construction provides increased stability and durability under the high-torque output of modern cordless platforms.

These spade bits are suited for residential and light commercial rough-in work where drilling through dimensional lumber, studs, joists, and plates is required. Electricians, plumbers, and HVAC installers routinely use spade bits in this size range to bore wire and pipe runs through framing. The optimized curved paddle design accelerates chip evacuation, helping maintain consistent cutting speed during repetitive drilling tasks and extending battery runtime on cordless tools. Each pack contains 2 bits, making it practical to keep a spare on hand during active rough-in work.

Key Features

• Self-feeding speed-tip design pulls the bit into wood without excess downward pressure
• Optimized curved paddle promotes aggressive chip evacuation for faster, cleaner holes
• Impact-strong shank rated for use in cordless and corded impact drivers and drill drivers
• 1 inch diameter x 6 inch length suits wire and pipe rough-in through standard framing lumber
• Pack of 2 bits included per unit

Compatibility

Designed for use in standard 3/8-inch and 1/2-inch chuck cordless and corded drill drivers and impact drivers capable of accepting hex-shank spade bits.

Installation Notes

Spade bits in this category are typically used by electricians, plumbers, and HVAC technicians during rough-in framing stages. Ensure all power to the tool is switched off before changing bits, and confirm the chuck or collet is fully secured before drilling. Follow applicable building codes, including NEC guidelines for electricians, regarding hole placement relative to framing members and required protection plates. Avoid forcing the bit through knots or dense grain at full speed, as this can accelerate tip wear.