Freud DSP2010 Speed Demon Spade Bit 1/4x6 Inch 5 Pack

Product Description

The FREUD DSP2010 Speed Demon spade bit is a high-performance wood boring bit engineered for fast, clean hole making in wood applications. Measuring 1/4 inch in diameter and 6 inches in length, this bit features a self-feeding speed-tip design that draws the bit into the material without extra downward pressure, reducing operator fatigue. The optimized curved paddle geometry accelerates chip evacuation, keeping the flutes clear and allowing more holes per battery charge on cordless tools. Sold in a 5-pack, this bit is built impact-strong for reliable shank stability in both cordless and corded impact drivers and drill drivers.

This spade bit is suited for residential and light commercial carpentry, electrical rough-in, plumbing rough-in, and general woodworking tasks where fast, clean through-holes are required. The 6-inch length provides reach through standard framing lumber and dimensional materials. The 1/4-inch diameter is commonly used for wire and small-fastener pass-through holes. Electricians, plumbers, and carpenters running wire or pipe through wood framing will find this bit a practical fit for daily production work.

Key Features

• Self-feeding speed-tip design reduces downward pressure and speeds up hole making
• Optimized curved paddle promotes rapid chip evacuation for sustained performance per charge
• Impact-strong shank construction provides stability in cordless and corded impact drivers
• 1/4-inch diameter by 6-inch length suits wire and small fastener pass-through applications
• Sold as a 5-pack for job-site value and bit replacement availability

Compatibility

Designed for use with standard cordless and corded drill drivers and impact drivers accepting 1/4-inch hex or standard round shanks. Intended for drilling in wood and wood-based materials.

Installation Notes

Installation is performed by electricians, plumbers, and carpenters during framing and rough-in stages. Secure the bit fully in the chuck before operating and confirm the driver is set to an appropriate speed and torque range for the material thickness. Always wear eye protection when drilling to guard against chip ejection. Inspect the bit tip for wear or deformation before each use and replace damaged bits promptly.