Freud DSP1090 Speed Demon Spade Bit 1.5x4in 5 Pack

Product Description

The FREUD DSP1090 is a Speed Demon spade bit designed for fast, clean hole drilling in wood. Each bit measures 1.5 inches in diameter and 4 inches in length. The speed-tip point is self-feeding, reducing the effort needed to drive through material and increasing hole-making speed compared to standard spade bits. The shank is impact-rated for compatibility with both cordless and corded impact drivers and drill drivers. This package includes 5 bits. Licensed HVAC techs, plumbers, and electricians commonly reach for spade bits when drilling through framing, joists, and plates during rough-in work.

The DSP1090 is suited for residential and light commercial rough-in applications where crews need to bore through wood framing quickly. The curved paddle geometry accelerates chip evacuation, which helps maintain drilling speed over multiple holes per battery charge. The impact-rated shank holds up under the higher torque output of modern cordless impact drivers, making this bit a practical choice for installers working with power-hungry cordless platforms on the job site.

Key Features

• Self-feeding speed-tip design reduces feed pressure and increases hole-making speed
• Optimized curved paddle promotes aggressive chip evacuation for sustained performance
• Impact-rated shank for use with cordless and corded impact drivers and drill drivers
• 1.5-inch diameter cuts appropriately sized holes for common pipe and conduit rough-in
• 4-inch overall length provides reach through standard framing lumber
• Sold as a 5-piece pack for job site supply

Compatibility

Designed for use in wood with cordless and corded drill drivers and impact drivers equipped with a standard bit chuck.

Installation Notes

Installation of spade bits is performed by carpenters, electricians, plumbers, and HVAC technicians during rough-in framing stages. Ensure the drill or impact driver is powered off and the bit is fully seated in the chuck before use. Follow applicable codes such as NEC or IPC for minimum hole placement and required protection plates when boring near framing edges. Wear appropriate eye protection when drilling overhead or through composite materials.