Freud DBH300 Magnetic Bit Holder 3 Inches 5 Pack

Product Description

The FREUD DBH300 is a 3-inch magnetic driver bit holder designed to extend drill and impact driver reach in confined or hard-to-access fastening locations. A high-strength permanent magnet holds bits and fasteners securely, minimizing wobble during screw and nut driving. The torque-resistant construction absorbs rotational stress, reducing wear on both the holder and the installed bit. Built to handle the demands of cordless and corded impact drivers as well as standard drill drivers, this bit holder is suited for electricians, plumbers, HVAC techs, and general contractors who need reliable fastening access in tight spaces. Sold in a pack of 5.

The DBH300 is appropriate for residential and light commercial trade work where frequent fastening in restricted areas is required. Its impact-rated shank construction maintains stability under the higher torque output of modern cordless impact drivers. The 3-inch length provides added reach without sacrificing the anti-wobble control needed for accurate, consistent fastener seating. Compatible with standard hex-shank driver bits used across electrical, HVAC, plumbing, and general construction applications.

Key Features

• High-strength permanent magnet provides secure, anti-wobble bit and fastener grip
• Torque-resistant design absorbs rotational stress to extend holder and bit service life
• Impact-rated shank delivers increased stability in cordless and corded impact drivers
• 3-inch length extends drill reach into hard-to-access areas
• Compatible with standard hex-shank driver bits
• Sold as a 5-pack for jobsite convenience

Compatibility

Designed for use with cordless and corded impact drivers and drill drivers accepting a standard hex-shank bit holder. Fits standard hex-shank driver bits across common fastening applications.

Installation Notes

Insert the DBH300 into the chuck of a compatible drill or impact driver before engaging any fastener. Ensure the chuck is fully seated and locked onto the bit holder shank before operation. When working in energized electrical panels or near live circuits, always de-energize and verify lockout/tagout procedures per applicable NFPA 70E requirements before using any drill or impact driver accessory.