Enerco F163062 Power Vented Unit Heater 150000 Btu Nat Gas

Product Description

The ENERCO F163062 is a 150,000 BTU/h power-vented unit heater designed for large-space heating in industrial and commercial environments. It fires on natural gas and runs on 110 volts, single phase. The aluminized steel heat exchanger transfers heat efficiently while resisting the corrosive byproducts of combustion. A built-in fan draws room air across the heat exchanger and distributes warm air through adjustable louvers that lock in three positions, giving the installer control over airflow direction. A dedicated power-vent system exhausts combustion gases through a single vent pipe, reducing flue complexity and cutting rough-in time on the job.

This unit heater is suited for factories, warehouses, garages, and similar open commercial or industrial spaces up to 5,000 square feet. The single-pipe power-vent configuration makes it practical for buildings where a conventional gravity-vent or B-vent run would be difficult to route. HVAC technicians and licensed gas fitters handling large-space heating retrofits or new construction installs are the primary trade for this equipment. The unit ships ready for natural gas service only — LP conversion is not included.

Key Features

• 150,000 BTU/h heating capacity covers spaces up to 5,000 square feet
• Aluminized steel heat exchanger for durability in demanding environments
• Power-vent system exhausts through a single pipe, simplifying installation
• Adjustable air louvers with three locking positions for directional airflow control
• Natural gas operation at 110 volts AC

Compatibility

Designed for natural gas service in residential, commercial, and light industrial heating applications requiring high-capacity forced-air output. LP conversion hardware is not included and not supported by this configuration.

Installation Notes

Installation must be performed by a licensed HVAC technician or gas fitter in accordance with local mechanical codes and the IFGC. Shut off the gas supply and disconnect electrical power before making any connections. The power-vent system requires proper sizing and routing of the exhaust pipe per the manufacturer instructions to prevent flue-gas recirculation. Do not operate on LP gas without the correct conversion kit, as this unit is configured for natural gas only.

Technical Specifications

• Heating Capacity: 150,000 BTU/h
• Fuel Type: Natural Gas
• Electrical Rating: 110 volts AC
• Heating Area: 5,000 square feet
• Heat Exchanger Material: Aluminized Steel
• Vent Type: Power Vent, Single Pipe

Standard Information

• Brand: ENERCO
• Manufacturer Part Number: F163062