Emtek LC4-DBLCH237R-US19 Radius Deadbolt Latch Flat Black

Product Description

The EMTEK LC4-DBLCH237R-US19 is a radius-corner deadbolt latch designed for residential and light commercial door hardware installations. It features a 2-3/8 inch backset, making it compatible with standard door prep dimensions found in most interior and exterior door applications. The flat black finish provides a consistent aesthetic match for coordinating door hardware sets. This latch is the mechanical bolt component used within a complete deadbolt lockset assembly and is typically installed by locksmiths, finish carpenters, or general contractors during new construction or hardware replacement projects.

This latch is suited for standard single-bore door preps where a 2-3/8 inch backset is required. The radius faceplate corners allow it to fit door edge mortises without requiring square-corner chiseling, which simplifies installation in pre-routed door frames. It is sold as a single unit and is intended for use as part of a complete EMTEK deadbolt assembly. Typical applications include residential entry doors, interior privacy doors, and light commercial door hardware installations.

Key Features

• 2-3/8 inch backset fits standard residential door prep dimensions
• Radius faceplate corners eliminate the need for square-corner chiseling during install
• Flat black finish for consistent hardware coordination
• Compact profile at 3.31 inches length, 2.25 inches width, and 1 inch height
• Sold individually, compatible with complete EMTEK deadbolt assemblies

Compatibility

Designed as an OEM-style replacement or component latch for EMTEK deadbolt lockset assemblies requiring a 2-3/8 inch backset with a radius faceplate corner configuration.

Installation Notes

Installation should be performed by a qualified locksmith, finish carpenter, or experienced installer following applicable local building codes. Disengage the door from its frame and ensure no load is placed on the latch during installation. Use a chisel or appropriate mortising tool only if faceplate seating requires adjustment. Verify backset measurement from the door edge to the center of the bore hole before installation to confirm fitment.