Emtek 86686US19 Jasper Cabinet Pull 3.5 in Flat Black

Product Description

The EMTEK 86686US19 is the Jasper Cabinet Pull finished in Flat Black, designed for cabinet doors and drawers in residential and light commercial cabinetry applications. The pull measures 3.5 inches center to center, making it a standard sizing for most cabinet door and drawer installations. At 0.3 pounds, it is a lightweight hardware component suited for frequent daily use. Licensed contractors, finish carpenters, and skilled tradespeople typically specify and install this type of cabinet hardware during new construction, renovation, or cabinet refacing projects. The Flat Black finish provides a consistent, matte appearance that coordinates with a wide range of cabinet styles and interior design themes.

This cabinet pull is intended for use on cabinet doors and drawer fronts in kitchens, bathrooms, laundry rooms, and built-in cabinetry. The 3.5-inch center-to-center spacing is a commonly specified dimension that fits standard pre-drilled cabinet door and drawer configurations. It ships as a single unit (sold each) and is assembled to order. Installation requires basic hand tools including a screwdriver and, in some cases, a drill for pilot holes if cabinet faces are not pre-drilled to the correct spacing.

Key Features

• 3.5-inch center-to-center hole spacing for standard cabinet configurations
• Flat Black finish for a matte, low-sheen appearance
• Overall length of 7 inches with a width of 2.7 inches and height of 1.2 inches
• Lightweight construction at 0.3 pounds
• Sold individually, allowing single-unit or bulk ordering

Compatibility

Designed as a standard replacement or new-installation cabinet pull for residential and light commercial cabinetry with 3.5-inch center-to-center hole spacing.

Installation Notes

Cabinet pulls of this type are installed by finish carpenters, cabinetmakers, or general contractors as part of cabinetry finish-out. Before installation, verify that the cabinet face is pre-drilled to the correct 3.5-inch center-to-center spacing or mark and drill pilot holes as needed. Use the appropriate screw length for the cabinet door or drawer front thickness to ensure a secure fit without breakthrough. Do not overtighten mounting screws, as this can crack or deform the cabinet face material.