Emtek 2241US4 Hinge Pivot Stop Satin Brass

Product Description

The EMTEK 2241US4 is a hinge pivot stop finished in satin brass, designed to control door swing by limiting pivot travel at the hinge point. This hardware mounts directly at the hinge location, providing a low-profile stop solution that keeps the door from swinging beyond its intended range. At 0.1 pounds and compact dimensions of 0.1 inches by 1.9 inches by 0.7 inches, the 2241US4 is a lightweight, unobtrusive component suited for interior door applications. Installation is typically handled by carpenters, finish trim contractors, or experienced DIYers during door hardware rough-in or finish stages.

The 2241US4 pivot stop is intended for interior residential door installations where a traditional floor or wall stop is not practical or desired. The hinge-mounted design makes it a clean alternative in applications where aesthetics matter and surface-mounted stops would interrupt the visual line of the door or baseboard. The satin brass finish coordinates with other US4 finish hardware in a door set.

Key Features

• Hinge-mounted pivot stop design keeps door swing controlled at the source
• Satin brass (US4) finish for a consistent hardware set appearance
• Compact profile: 0.1 inches x 1.9 inches x 0.7 inches
• Lightweight at 0.1 pounds — minimal added load on hinge
• Sold individually (each)

Compatibility

Designed as an OEM-style hinge pivot stop for standard interior door hinge applications where a US4 satin brass finish is specified.

Installation Notes

Installation is performed by a finish carpenter or door hardware installer using basic hand tools. Ensure the door is fully hung and swings freely before fitting the pivot stop to confirm correct placement. Verify finish compatibility with existing hinge hardware before installation. No special power tools or permits are typically required for this hardware component.