Emtek 220304US4 Rectangular Flush Pull Satin Brass

Product Description

The EMTEK 220304US4 is a modern rectangular flush pull finished in Satin Brass, designed for use on sliding doors, pocket doors, and cabinet panels where a low-profile pull is required. The flush-mount form factor sits recessed into the door face, keeping the pull from protruding into the door jamb travel path. At 4 inches in nominal length, it provides a clean, architectural grip point suited to both residential and light commercial millwork applications. Sold individually, this pull is typically specified during new construction or remodel finish carpentry work where door hardware selections are coordinated with interior design themes.

This flush pull is appropriate for pocket doors, barn door hardware setups requiring a recessed grip, and cabinet or furniture applications where a surface-mounted pull would interfere with operation. The Satin Brass finish suits transitional and contemporary interior schemes. It is sold as a single unit and is field-installed by carpenters, finish trim contractors, or skilled owner-builders during the hardware trim-out phase of construction or renovation.

Key Features

• Flush-mount profile keeps pull recessed within the door face, preventing interference with door frames or jambs
• Modern rectangular form factor suits contemporary and transitional interior design applications
• Satin Brass finish (US4) provides a warm, brushed tone consistent with current architectural hardware standards
• Compact overall footprint: 5.7 inches long by 2 inches wide by 0.9 inches deep
• Lightweight construction at 0.1 pounds, suitable for doors and cabinet panels without adding significant load
• Sold individually, allowing single-unit replacement or custom quantity ordering

Compatibility

Designed as an OEM-style flush pull replacement or new-install component for pocket doors, sliding doors, and cabinet panels requiring a recessed grip in a standard rectangular cutout configuration.

Installation Notes

Installation is typically performed by a finish carpenter or trim contractor using a router or mortising chisel to cut the door face recess to the pull body dimensions. Verify the door panel thickness is sufficient to accommodate the 0.9-inch depth of the pull body before mortising. Fasten per manufacturer hardware using appropriate screw length for the door material. No electrical shutoff or specialized trade licensing is required for standard door hardware installation.