Elkay PSR25210 Drop-in Kitchen Sink 25 Inch Stainless Steel

Product Description

The ELKAY PSR25210 is a single bowl drop-in kitchen sink constructed from 20-gauge Type 304 stainless steel, designed for residential kitchen installations. The sink measures 25 inches x 21-1/4 inches x 7-1/2 inches, providing a large, uninterrupted basin for washing, rinsing, and staging dishes. A centrally located 3-1/2 inch drain optimizes water flow and reduces standing water. Sound-deadening pads are bonded to the underside of the bowl to dampen vibration and reduce noise during use. A U-channel mounting design accepts standard installation clips, allowing a licensed plumber or experienced installer to set the sink without extensive under-counter access.

This sink is suited for residential kitchen remodels and new construction where a drop-in configuration is specified. It requires a minimum base cabinet width of 30 inches. The countertop cutout dimension is 24-3/8 inches x 20-5/8 inches, which fits a range of standard countertop materials including laminate, solid surface, and stone. The 1-1/2 inch corner radius gives the sink a clean finished appearance once set into the countertop opening. Manufactured in the USA.

Key Features

• 20-gauge Type 304 stainless steel construction for corrosion resistance and long service life
• Single bowl design at 25 inches x 21-1/4 inches x 7-1/2 inches deep for maximum basin capacity
• Center drain placement at 3-1/2 inches promotes efficient drainage and reduces standing water
• Sound-deadening pads reduce vibration and noise during high-volume use
• U-channel mounting system accepts standard drop-in clips for straightforward installation
• Countertop cutout of 24-3/8 inches x 20-5/8 inches fits standard 30-inch minimum cabinet openings

Compatibility

Designed as a drop-in replacement or new-installation sink for residential kitchen countertops requiring a minimum 30-inch base cabinet and a countertop cutout of 24-3/8 inches x 20-5/8 inches.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and the International Plumbing Code (IPC). Shut off the water supply and disconnect existing drain lines before removing any existing sink. Apply a continuous bead of silicone sealant around the underside of the sink rim before setting into the cutout, then secure with the provided mounting clips from below. Verify drain alignment with the existing drain rough-in before final tightening.