Electro Hardware P625M07F16-632 Female Standoff 6-32

Product Description

The ELECTRO HARDWARE P625M07F16-632 is a round female standoff designed to create fixed spacing between panels, circuit boards, or structural components in mechanical and electronic assemblies. This standoff features a 6-32 threaded bore with a 1-inch thread depth, a 2-inch overall length, and a 0.25-inch outside diameter. Constructed from 18-8 and Grade 303 stainless steel with a bright finish, it delivers corrosion resistance and dimensional consistency suited to demanding environments. HVAC control panels, electrical enclosures, and panel fabrication applications are common uses. Licensed electricians, panel builders, and sheet metal fabricators are the typical installers.

This standoff is intended for use in panel assembly, electronic chassis fabrication, and similar applications requiring precise, repeatable standoff spacing. The fully threaded 6-32 female bore accepts standard 6-32 machine screws from both ends, allowing secure two-point fastening. Its round body profile and bright stainless finish make it suitable for both interior and exterior enclosure work where appearance and corrosion resistance matter. Single-piece packaging makes it straightforward to source in exact quantities for service or repair jobs.

Key Features

• 6-32 female thread with 1-inch thread depth on a fully threaded bore
• 2-inch overall length for consistent panel and board spacing
• 0.25-inch outside diameter in a round body profile
• 18-8 and Grade 303 stainless steel construction for corrosion resistance
• Bright finish meets QQ-S-763 federal fastener standard
• Length tolerance held to plus or minus 0.005 inches for precision fitment

Compatibility

Designed as an OEM-style replacement or new-installation standoff for assemblies using 6-32 machine screws, including electrical enclosures, HVAC control panels, and electronic chassis requiring a 2-inch standoff height with a 0.25-inch round body.

Installation Notes

Installation is typically performed by electricians, panel builders, or electronics technicians. De-energize all circuits in the assembly before installing or removing standoffs in live enclosures. Use a hex driver or open-end wrench sized to the 0.25-inch body where torque control is needed, and avoid over-tightening to prevent thread damage in the mating material. Follow applicable NEC guidelines for enclosure assembly and hardware fastening.