Electro Hardware MM1341M06-MSC Hex Board Standoff 6-32 3/4 in

Product Description

The ELECTRO HARDWARE MM1341M06-MSC is a male-male hex circuit board standoff designed to create fixed spacing between circuit boards or between a board and a mounting surface. Machined from aluminum to Grade T3 and finished with a clear coating, this standoff meets QQ-A-225A Comp 2 specifications. It features a 6-32 threaded stud on each end, an overall length of 0.75 inches, and a hex body measuring 3/16 inches across flats. Electronics technicians, panel builders, and electrical contractors use these fasteners when assembling control panels, PCB stacks, and enclosure mounting configurations where precise board-to-board clearance and secure mechanical attachment are required.

This standoff is suited for use in low-voltage control boards, industrial electronics assemblies, HVAC control panel fabrication, and general electrical enclosure builds. The inch-system hex body allows standard hex drivers and nut drivers to apply controlled torque without slipping. At 0.15 pounds per unit, the lightweight aluminum construction keeps overall assembly weight low in weight-sensitive panel builds. The 6-32 male threads on both ends allow the standoff to thread directly into tapped holes or mate with standard 6-32 hex nuts and screws.

Key Features

• Male-male 6-32 threaded ends for direct board-to-board or board-to-panel mounting
• Hex body profile with 3/16 inch width across flats for positive driver engagement
• Overall length of 0.75 inches with a length tolerance of -0.005 to 0.005 inches
• Aluminum construction, Grade T3, for lightweight and corrosion-resistant performance
• Clear finish meets QQ-A-225A Comp 2 fastener standard
• Inch measurement system; compatible with standard SAE tooling and 6-32 hardware

Compatibility

Designed as a standard 6-32 male-male hex circuit board standoff for use with any PCB or panel assembly that accepts 6-32 threaded fasteners in an inch-system configuration.

Installation Notes

Installation is typically performed by electronics technicians or panel wiring professionals. Power down and de-energize all circuits before working inside any control panel or enclosure. Use a properly sized hex driver or nut driver matching the 3/16 inch across-flats dimension to avoid rounding the hex body. Do not overtighten; aluminum threads can strip if excessive torque is applied.