Electro Hardware ESO-632-16ZI Hex Board Standoff 6-32

Product Description

The ELECTRO HARDWARE ESO-632-16ZI is a female hex circuit board standoff designed to create fixed, threaded spacing between printed circuit boards and mounting surfaces. Manufactured from steel with a zinc-plated finish, this standoff measures 0.5 inches in overall length with a 0.25-inch width across flats and accepts a 6-32 thread. The hex body provides a wrench-flat profile for controlled installation torque, while the female thread receives a mating screw or stud on both ends. This fastener is a standard component in electronic enclosure assemblies, industrial control panels, and PCB mounting applications handled by electricians, electronics technicians, and panel builders.

This standoff is suited for residential and commercial electronic assemblies where secure, repeatable PCB standoff height is required. Typical applications include mounting circuit boards inside HVAC control panels, electrical enclosures, relay panels, and industrial equipment chassis. The 6-32 thread size and 0.5-inch body length are common in low-voltage electronic assemblies. Each package contains 25 pieces, making this suitable for production assembly runs or service bench stock. The zinc plating provides corrosion resistance appropriate for indoor panel environments.

Key Features

• Female 6-32 threaded hex standoff for PCB-to-chassis mounting
• Steel construction with zinc-plated finish for corrosion resistance
• 0.5-inch overall length provides consistent board standoff height
• 0.25-inch width across flats allows standard hex wrench or nutdriver installation
• Self-clinching with through-hole fastening method for secure panel attachment
• Sold in a pack of 25 for bench stock or small production use

Compatibility

Designed as a standard 6-32 female hex standoff for use in printed circuit board mounting applications requiring a 0.5-inch standoff height within electrical enclosures and control panels.

Installation Notes

Installation is performed by electricians or electronics technicians during panel assembly or board replacement. Power down and de-energize all circuits before working inside any control enclosure. Use an appropriately sized hex nutdriver or open-end wrench on the 0.25-inch flats to seat the standoff without over-torquing the thread engagement. Follow applicable NEC guidelines for enclosure work when installing within listed electrical assemblies.