Electro Hardware 4111AM07F16 Captive Screw 6-32 Unc

Product Description

The ELECTRO HARDWARE 4111AM07F16 is a slotted-drive captive screw designed to remain retained in an assembly even when fully backed out. Threaded to the 6-32 UNC standard, it features a rounded head with a 0.375-inch diameter and a 0.1875-inch head height. The fastener is machined from 18-8 stainless steel and left uncoated, making it well-suited for enclosures, panels, and equipment where corrosion resistance and panel retention are required. With a thread length of 0.625 inches under the head, it provides adequate engagement for light-gauge panel assemblies. HVAC technicians, electricians, and panel builders commonly use captive screws when frequent access to internal components is required.

This captive screw is intended for use in control panel assemblies, electrical enclosures, and equipment housings where a retained fastener prevents loss during service or repeated access. The 6-32 UNC thread pattern is a common sizing found in light-gauge sheet metal and electronic enclosure applications. Its uncoated 18-8 stainless steel construction meets QQ-S-763 requirements, making it appropriate for both indoor and mildly corrosive environments. It is sold individually but carries a minimum order quantity of 10 units.

Key Features

• Captive design keeps the screw retained in the panel when fully disengaged
• 6-32 UNC thread standard for common light-gauge enclosure and panel applications
• 18-8 stainless steel construction meets QQ-S-763 material standard
• Rounded head with 0.375-inch diameter and 0.1875-inch head height
• 0.625-inch thread length under head for adequate panel engagement
• Uncoated finish suitable for corrosion-resistant applications without added plating

Compatibility

Designed as a standard 6-32 UNC captive fastener for use in light-gauge electrical enclosures, control panels, and equipment housings requiring a retained screw solution.

Installation Notes

Captive screws of this type are typically installed by electricians, panel builders, or HVAC service technicians working on control enclosures. De-energize and lock out the panel before servicing any fasteners on live electrical enclosures in accordance with applicable NFPA 70 (NEC) requirements. Use a hand-held flat-blade screwdriver sized to the slotted head to avoid cam-out and head damage. Do not over-torque into light-gauge sheet metal threads, as this can strip the mating tapped hole.