Electro Hardware 1483M09F16-632 Hex Standoff 6-32 2.25in Ss

Product Description

The ELECTRO HARDWARE 1483M09F16-632 is a male-female hex circuit board standoff designed to create precise spacing between printed circuit boards or between a board and a mounting surface. Machined from 18-8 and Grade 303 stainless steel with an anodized finish, this standoff meets QQ-S-763 fastener standards. It features a 6-32 thread on both the male and female ends, an overall length of 2.25 inches, a hex body length of 2 inches, and a width across flats of 0.25 inches. Licensed electricians, electronics technicians, and panel builders install these standoffs in control panels, enclosures, and PCB assemblies where corrosion resistance and dimensional accuracy are required.

This standoff is suited for use in residential and commercial electrical control panels, industrial enclosures, HVAC control boards, and electronic equipment assemblies. The stainless steel construction makes it a reliable choice in environments where moisture or oxidation could compromise a zinc-plated or brass alternative. It is sold individually and is appropriate wherever a 6-32 threaded male-female hex standoff with a 2.25-inch overall length is specified by the board layout or enclosure design.

Key Features

• 6-32 male-female thread configuration for direct PCB stacking or panel mounting
• Overall length of 2.25 inches with a 2-inch hex body and 0.25-inch thread length on the male end
• 0.25-inch width across flats for standard hex driver or wrench installation
• 18-8 and Grade 303 stainless steel construction meets QQ-S-763 fastener standard
• Anodized finish for added surface protection
• Length tolerance held to plus or minus 0.005 inches for precise board spacing

Compatibility

Designed as an OEM-style replacement or new-installation standoff for circuit board assemblies and electrical enclosures requiring a 6-32 thread, 2.25-inch overall length, male-female hex standoff in stainless steel.

Installation Notes

Installation is typically performed by a licensed electrician or electronics technician. De-energize all circuits in the enclosure or panel before working on board mounting hardware. Use a 0.25-inch hex driver or appropriately sized nut driver to seat the standoff without over-torquing the stainless threads. Follow applicable NEC guidelines and equipment manufacturer instructions when mounting control boards inside electrical enclosures.