Ecm Industries Llc SDT-10 10-in-1 Circuit Alert Screwdriver

Product Description

The ECM INDUSTRIES LLC SDT-10 is a 10-in-1 multi-bit screwdriver with an integrated circuit alert sensor that detects AC voltage without contacting live wires. The snap-in sensor allows electricians and technicians to identify energized circuits safely before making contact. The fully insulated shaft and handle provide an additional layer of protection during service work. Ten drive configurations are built into a single tool, reducing the number of individual drivers needed on a service call. This tool is suited for residential and light commercial electrical work where compact, multi-function hand tools are standard.

The SDT-10 is used in panel work, device rough-in, low-voltage wiring, and general electrical service applications. The voltage detection feature makes it practical for troubleshooting outlets, fixtures, switches, and wiring terminations where confirming de-energized status before service is a routine step. Electricians, HVAC technicians, and maintenance professionals who need a carry-everywhere diagnostic screwdriver will find the combined detection and drive capability useful on daily service routes.

Key Features

• Snap-in sensor detects AC voltage without contacting live conductors
• Insulated shaft and handle protect the user from voltage exposure
• Includes No. 1 and No. 2 Phillips bits
• Includes 3/16 inch and 1/4 inch slotted bits
• Includes R1 and R2 Robertson bits and 1/4 inch and 5/16 inch hex nut drivers
• Includes No. 10 and No. 15 Torx bits

Compatibility

Designed as a general-purpose multi-bit screwdriver with voltage detection for use in residential and light commercial electrical service applications.

Installation Notes

This tool is intended for use by qualified electricians and trained service technicians. Always verify the voltage detection feature is functioning before relying on it to confirm a de-energized circuit, and follow lockout/tagout procedures as required by applicable codes. Do not use the tool as a primary lockout/tagout device. Inspect the insulated shaft and handle for damage before each use and remove from service if insulation is cracked or compromised.