Ecm Industries Llc 46-408UVB Cable Tie 8 in Black 100 Pack

Product Description

The ECM INDUSTRIES LLC 46-408UVB is an 8-inch black nylon cable tie designed for trade and industrial applications that demand superior holding strength. Each tie features a patented dual-sided locking tooth design that delivers 50% greater tensile strength than the industry standard, rated at 120 pounds. Manufactured using one-piece, injection-molded nylon 6/6 construction, these ties eliminate the risk of component separation or hardware failure under load. Raised ridges on the bent tip provide a secure grip during installation, and the tie locks firmly without stretching or sliding once cinched.

These cable ties are suited for electrical, HVAC, plumbing, and general mechanical applications where a reliable, rugged bundle management solution is required. The black nylon material offers UV resistance appropriate for both indoor and outdoor environments. Each bag contains 100 ties, making this pack practical for job site use or van stock. The 2-inch maximum bundle diameter accommodates a wide range of wire harnesses, conduit bundles, and hose groupings commonly encountered in trade work.

Key Features

• Patented locking teeth on both sides of the tie for 50% greater tensile strength than industry standard
• 120-pound tensile strength rating for high-load bundling applications
• One-piece injection-molded construction eliminates loose or broken components
• Made from durable 100% nylon 6/6 material suited for rugged environments
• Raised ridges on bent tip provide secure grip during cinching
• 100 ties per bag for efficient job site or shop use

Compatibility

Designed as a general-purpose cable tie for use in electrical, HVAC, plumbing, and mechanical trade applications requiring a black nylon 8-inch tie with high tensile strength.

Installation Notes

Cable ties are typically installed by electricians, HVAC technicians, and plumbers as part of wire management, conduit support, or equipment service work. Power down any electrical circuits before bundling wiring. Use flush-cut diagonal pliers or a dedicated tie gun to trim excess tail without leaving a sharp edge. Follow applicable NEC or local code requirements for tie placement intervals and bundle support spacing.